Introduction; Connections, Operating And Display Elements - Cameo AURO BEAM 200 DC Bedienungsanleitung

INTRODUCTION

MOVING HEAD AURO BEAM 200 WITH DISCHARGE LAMP
CLAB200DC
CONTROL FUNCTIONS
13-Channel and 16-channel DMX control
Master/Slave operation
Standalone functions
RDM
FEATURES
132 W OSRAM SIRIUS HRI discharge lamp. Colour wheel with 13 brilliant colours + white and split colours. 14 fixed gobos + open. 2 rotating
prisms. Focus via DMX. Strobe. Pan and tilt motors with 16-bit resolution. Automatic position correction.
Temperature-controlled fan. RDM-enabled. Battery-powered display for mains-free configuration. 3- and 5-pin DMX connections. Neutrik
powerCON mains connections IN and OUT. 2 x Omega mounting brackets included. Operating voltage 100–240 V AC. Power consumption 270W
The spotlight features the RDM standard (remote device management). Remote device management allows the user to view status and
configuration of RDM terminals via an RDM-capable controller.

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1
4
3
1 POWER IN
Neutrik powerCON mains input socket. Operating voltage 100 - 240 V AC / 50 - 60Hz. Connection via the supplied PowerCON mains coble.
2
POWER OUT
Neutrik powerCON mains output socket. Facilitates power supply to other CAMEO lights. Ensure that the total current consumption of all
connected devices does not exceed the value specified on the device in amperes (A).
3 FUSE
Fuse holder for 5 x 20mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
4 DMX IN
Male 3-pin and 5-pin XLR sockets for connection to a DMX control device (e.g. DMX console).
5
DMX OUT
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal.
2
5
5