Possible Problems; Guarantee - ATIKA ASP 8-1050 Bedienungsanleitung

Problem
Logs are not being split properly
(insufficient splitting performance)
Log splitter does not operate, although the
motor is running
Motor starts, but splitting column is not
retracted
Motor doesn't start
Please observe the enclosed terms of guarantee.
P o s s i b l e p r o b
P o s s i b l e p r o b
possible cause
⇒ The log is not positioned correctly
⇒ The log exceeds the maximum dimen-
sions or the wood is too hard for the per-
formance of the machine
⇒ Splitting blade does not split log
⇒ Hydraulic pressure too low
⇒ Release rods bent (hydraulic tappet not
quite pressed in)
⇒ Incorrect connecting lead (longer than
10 m or too small cable cross-section)
⇒ Valve does not open due to loose
connections
⇒ The operating levers or parts thereof are
bent.
⇒ Wrong direction of rotation of motor
⇒ No electrical power
⇒ 2-phase mode in threephase motor
⇒ Connection cable defective
⇒ Electric motor defective
⇒ Switch defective (DS)
⇒ Switch or capacitor defective
G u a r a n t e
G u a r a n t e
26
l e m s
l e m s
remedy
⇒ Reposition the log correctly
⇒ Cut the log to the required dimen-
sions (page 19)
⇒ Sharpen splitting blade, check for
burrs or notches (page 22)
⇒ Check the oil level and add more oil
if necessary. (page 22)
If the problem cannot be rectified, re-
fer to the manufacturer or other ap-
proved service centre.
⇒ Arrange for manufacturer or author-
ised company to adjust the rods
⇒ Use the correct connecting lead
⇒ Check and tighten the parts
⇒ Have bent parts repaired by the
manufacturer or a company desig-
nated by him
⇒ Check motor's direction of rotation
and change (refer to page 19)
⇒ Check the fuse.
⇒ Have fuse and lead checked by
qualified electrician.
⇒ Replace the connection cable or
have it checked by an electrician.
⇒ To correct the problem, refer to the
manufacturer or other approved
service centre.
e
e