Technical Data; Possible Problems; Possible Cause - ATIKA ASP 10 N Bedienungsanleitung

T e c h n i c a l d a t a
T e c h n i c a l d a t a
Model
Type
Splitting force
Log length
Log diameter
Stroke
Feed speed
Return speed
Hydraulic oil (max.)
Hydraulic pressure
Electric motor performance (power consumption)
Power supply
Dimensions
Weight
P o s s i b l e p r o b l e m
P o s s i b l e p r o b l e m
Problem
Logs are not being split
properly
(insufficient splitting
performance).
Splitting column moves
unsteadily or with strong
vibrations.
Splitting column does not
move in.
Motor starts, but splitting
column does not move in.
Motor will not start.
26
s
s

Possible cause

⇒ The log is not positioned correctly.
⇒ The log exceeds the maximum dimensions
or the wood is too hard for the performance
of the machine.
⇒ Splitting blade does not split log.
⇒ Hydraulic pressure too low.
⇒ Release rods bent (hydraulic tappet not
quite pressed in).
⇒ Incorrect connecting lead (longer than 10 m
or too small cable cross-section).
⇒ Air in the circuit.
⇒ Splitting column not sufficiently lubricated or
oiled.
⇒ Hydraulic pump defective.
⇒ Motor turns in wrong direction
⇒ No electrical power.
⇒ 2-phase mode in threephase motor.
⇒ Connection cable defective.
⇒ Electric motor defective.
ASP 10 N – 400
ASP 10 N – 400
100 kN (10 t) ± 10 %
max. 1300 mm
min. 120 mm – max. 400 mm
≈ 515 mm
approx. 0.05 m/sek.
approx. 0.25 m/sek.
10 litres
21.4 MPa (214 bar)
P 4.0 kW (S6-40%)
1
400 V 3~ 50 Hz, 16 A
length 580 x width 530 x height 1530 mm
approx. 175 kg
Remedy
⇒ Reposition the log correctly.
⇒ Cut the log to the required dimensions.
⇒ Sharpen splitting blade, check for burrs or
notches.
⇒ Check the oil level and add more oil if necessary.
If the problem cannot be rectified, refer to the
manufacturer or other approved service centre.
⇒ Arrange for manufacturer or authorised company
to adjust the rods.
⇒ Use the correct connecting lead.
⇒ Check the oil level and add more oil if necessary.
⇒ Lubricate
splitting
environmentally friendly spray oil.
If the problem cannot be rectified, refer to the
manufacturer or other approved service centre.
⇒ To correct the problem, refer to the manufacturer
or other approved service centre.
⇒ Check the motor direction
Threephase: adjust the motor direction
AC: To correct the problem, refer to the manu-
facturer or other approved service centre.
⇒ Check the fuse.
⇒ Have fuse and lead checked by qualified
electrician.
⇒ Replace the connection cable or have it checked
by an electrician.
⇒ To correct the problem, refer to the manufacturer
or other approved service centre.
column or oil with