Storage; Guarantee; Possible Faults - ATIKA ASP 8 N-2 Originalbetriebsanleitung

Storage

Before each storage
 Retract the splitting column
 Switch off device.
 Close the oil cap
 Pull out power plug
Store machines that are not in use in a dry locked place pro-
tected against frost and outside the reach of children and unau-
thorized persons.
Before extended storage, please observe the following to in-
crease the service life of the device and to ensure smooth
operation:
 Thoroughly clean the device.
 Check the device for damaged or worn parts.

Possible faults

Before each fault elimination:
 Switch off device.
 Pull out power plug
Problem
Logs are not being split properly
(insufficient splitting performance)
Splitting column moves unsteadily
or with strong vibrations.
Splitting column does not move in.
Motor starts, but splitting column
does not move in.
Motor does not start
In case of further faults or inquiries please contact your local dealer.
Possible Cause
 The log is not positioned correctly
 The log exceeds the maximum
dimensions or the wood is too hard
for the performance of the machine
 Splitting blade does not split log
 Oil leak
 Hydraulic pressure too low
 Incorrect connecting lead (longer
than 10 m or too small cable cross-
section).
 Air in the circuit
 Splitting column not sufficiently
lubricated or oiled
 Hydraulic pump defective
 Motor turns in wrong direction
 No power supply.

2-phase mode in threephase mo-
tor.
 Mains cable defective.
 Electric motor defective

Guarantee

Please observe the enclosed terms of guarantee.
Remedy
 Reposition the log correctly
 Cut the log to the required dimensions
 Sharpen splitting blade, check for burrs or notches
 Place a sheet of cardboard under the log splitter in
order to locate the leak. To correct the problem, re-
fer to the manufacturer
 Check the oil level and add more oil if necessary
If the problem cannot be rectified, refer to the man-
ufacturer
 Use the correct connecting lead
 Open oil tank cap
 Check the oil level and add more oil if necessary
 Lubricate splitting column or oil with environmental-
ly friendly spray oil.
If the problem cannot be rectified, refer to the man-
ufacturer
 To correct the problem, refer to the manufacturer
 Check the motor direction
Threephase: adjust the motor direction
 Check fuses.

Have fuse and lead checked by qualified electri-
cian.
 Replace the connection cable or have it checked by
an electrician
 To correct the problem, refer to the manufacturer
19