ATIKA ASP 8-1050 Bedienungsanleitung Seite 22

3. Hold the log tight with the clamping claws (8).
4. Press both operat ing levers (9) down simultaneously –
Fig. 2.
The split-
ting blade (2)
falls do n w
and sp lits the
log.
5. Release the
two operating
levers, the
splitti ng blade
returns to its
initial position.
If you only release one operating le
ting blade remains where it is.
Special instructions for splitting logs:
Preparations:
The logs to be split should be cut to the maximum dimensio
(pa ge 19). Ensure also t
square.
Adjusting the stroke height
For piece s of wood smaller than approx. 500 mm and larger
qu ant ities, you can increase the working ra
the return path of the splitting blade.
1. Place the log
on the splitting
table and
press the two
operating lev-
ers (8) to
bring the split-
ting blade (2)
down to
approx. 2 cm
above the log.
Fig. 3
2. Release one
operating
lever so that
the blade
stays in this
position. Fig. 4
3. Switch the
machine off
and discon-
ne ct the
power.
4. Release the
second oper-
ating lever.
Unscrew
5. the
locking screw
using a socket
8
7
9
ver, then the split-
hat the logs are cut straight an
te by shortening
8
wrench. Guide the lift adjustment rod
the lift adjustment rod is stopped by the spring. Retighten
the locking screw. Fig. 5
2
5
Ad justing the height of the ta e
upper position of table for logs up to 590 mm
middle table position for logs up to 780 mm
ns
lower position of table for logs up to 1040 mm
d
6
3
1. Release the locking hooks. (10)
4
2 . Pull the table out.
3. Use the table in a position that
length and secure i
21
(18) upwards until
Locking screw
bl
middle table position
comes close to the log
t with the locking hooks.