Possible Cause - ATIKA ASP 11 N Originalbetriebsanleitung, Sicherheitshinweise, Ersatzteile

P o s s i b l e p
P o s s i b l e p
Fault
Engine does not start.
Engine is sputtering.
(runs erratically)
Decreasing engine power.
Logs are not being split properly
(insufficient splitting performance).
Splitting column moves unsteadily
or with strong vibrations.
Splitting column does not move in. ⇒ Hydraulic pump defective.
Downloaded from www.Manualslib.com
r o b l e m s
r o b l e m s

Possible cause

Engine cold.
Choke lever put to
Throttle lever put to
Ignition switch put to OFF.
Fuel valve put to
No fuel supply
Fuel old or contaminated.
Fault in the fuel line
Spark plug connector not placed on.
No ignition spark.
Engine flooded.
Carburettor defective
Engine defective.
Internal fault.
Choke lever put to
Spark plug connector not firmly placed on. Firmly place on the spark plug connector.
Vent in the tank cap blocked.
Fuel old or contaminated.
Incorrect carburetor adjustment.
Machine overloaded.
Machine is blocked.
⇒ The log is not positioned correctly.
⇒ The log exceeds the maximum
dimensions or the wood is too hard for
the performance of the machine.
⇒ Splitting blade does not split log.
⇒ Hydraulic pressure too low.
⇒ Release rods bent (hydraulic tappet not
quite pressed in).
⇒ Air in the circuit.
⇒ Splitting
lubricated or oiled.
manuals search engine
Remedy
Put choke lever to
.
. Put throttle lever to
Put ignition switch to ON.
Put fuel valve to
.
Check the fuel quantity
Drain the fuel into a container outdoors. Fill the
tank with fresh and clean fuel.
Check the fuel line for kinks or damages
Place on the spark plug connector.
a) Clean or replace the spark plug.
b) Check the ignition cable.
c) Fault cannot be eliminated?
Screw off, clean and dry the spark plug. Then pull
the cranking rope several times and reinstall the
spark plug.
Contact the manufacturer or the responsible
customer service respectively.
Replace the engine.
Contact the manufacturer or the responsible
customer service respectively.
. Put choke lever to
Clean the tank cap and the vent.
Drain the fuel into a container outdoors. Fill the
tank with fresh and clean fuel.
Have the caburetor adjusted correctly. (customer
service)
a) Reduce material feeding.
b) Do not exceed the max. branch diameter.
Thoroughly clean inside the machine.
⇒ Reposition the log correctly.
⇒ Cut the log to the required dimensions.
⇒ Sharpen splitting blade, check for burrs or
⇒ Check the oil level and add more oil if
⇒ Arrange
⇒ Check the oil level and add more oil if
column not sufficiently
⇒ Lubricate
If the problem cannot be rectified, refer to the
manufacturer or other approved service centre.
⇒ To correct the problem, refer to the
.
.
.
Get the manufacturer or authorised service staff
to check the ignition system.
.
notches.
necessary.
If the problem cannot be rectified, refer to the
manufacturer or other approved service centre.
for manufacturer
company to adjust the rods.
necessary.
splitting column
environmentally friendly spray oil.
manufacturer or other approved service centre.
or authorised
or oil with
35