Selecting Codes - Betamotor ALP4T 125 Bedienungsanleitung

Figure 2
Figure 3
Figure 4

20.2 Selecting codes

•Pressing SCROLL for a short time cycles
through the other codes until the display
appears as shown in Figure 2.
Table of codes
Model Alp 4.0
Motard M4
Code 0001
Wheel 2105
circ.
•After selecting the desired code, press
and hold down SCROLL until WS is
displayed in the bottom right corner
(Figure 4). Once the button is released,
the code is activated and the display
appears as shown in Figure 5.
•If the configuration is complete, there
are two possibilities:
- exiting the setup procedure and launch-
ing the test as described in paragraph
40.0 by turning the speedometer off
and then on again;
- checking the code as described in
paragraph 20.3.
•If no code is appropriate, repeat the
procedure until the display is as shown
in Figure 2, which can be obtained by
briefly pressing SCROLL while Figure
3 is displayed. Subsequently press
SCROLL until WS is shown and then
release it to activate the procedure de-
scribed in paragraph 20.4.
97
1
Alp 200 cc
0002 0003
2115 1830
GB