Setting The Number Of Pulses Per Wheel Revolution - Betamotor ALP4T 125 Bedienungsanleitung

Figure 6
Figure 7
Figure 8
After performing the procedure described
in paragraphs 20.1 and 20.2 and with
the display appearing as shown in Fig-
ure 5 or 6, press and hold down the
SCROLL button until the display is as
shown in Figure 7.
When SCROLL is released, the bars will
be replaced by 0000, or by the previ-
ously entered value with the leftmost digit
blinking. Pressing SCROLL for a short
time increases the value by one unit. Leav-
ing SCROLL inactive for 2 seconds will
cause the blinking of the second digit from
the left. Use the same procedure for the
second and all the other digits.
Once Ln has been entered, wait 2 sec-
onds until the value disappears from the
display. To alter the entered value, sim-
ply repeat the procedure. Briefly press-
ing the SCROLL button causes the dis-
play to appear as shown in Figure 6.
Once Ln has been entered, the page will
display the corresponding diameter, cal-
culated automatically by the instrument.
To change the value, follow the proce-
dure described for Figure 7. Alternatively,
wait until the value disappears from the
display and briefly press SCROLL. The
display will then appear as shown in Fig-
ure 8.
20.4.2 Setting the number of
pulses per wheel revolution
HALL Speed (number of pulses per wheel
revolution).
With the display appearing as shown in
Figure 8, press and hold down the
SCROLL button until the bars - - - - are
displayed. When the button is released,
either 00 or the previously loaded value
is displayed.The value is updated and
stored using the same procedure de-
scribed for Figure 7.
Pressing SCROLL for a short time causes
the display to appear as shown in Figure 9.
99
1
GB