Wheel Specifications; Engine Specifications; Preloaded Codes - Betamotor ALP4T 125 Bedienungsanleitung

1
10.1 Wheel specifications (factory loaded)
Size of the wheel fitting the revolution sensor. Enter the wheel diameter or circumfer-
ence in mm (maximum allowable values 9999; if, for example, the wheel diameter
is 695 mm, after the measurement has been entered the display should read 0695)
and the number of pulses per revolution (maximum allowable value 99). Once the
value has been entered, if the number of pulses is less than 10, e.g. 1, the display
should read 01.
NB: The SCROLL button can be operated in one of two ways:
Short operation (button pressed for ≤ 1 second): displays the next page.
Long operation (button pressed for ≥ 5 seconds): selects the currently displayed
function, allowing its values to be checked, entered, altered and, in some cases,
stored.
For the sake of convenience, reference will only be made to the SCROLL button on
the handlebars, but the same results can be obtained by using the MODE button on
the speedometer (the MODE button can only be operated while the vehicle is sta-
tionary).
10.2 Engine specifications (only if tachometer is active)
Number of pulses per revolution and maximum nominal number of revolutions re-
quired to adjust the bar. Any parameters entered while the sensor is not present will
not alter operation but will bring up the page on the LCD display with the parameters
and the bar set to zero. The sensor input is on connector pin 12. The number of
pulses per engine revolution uses the same criteria as the number of pulses per wheel
revolution, whereas the number of engine revolutions only requires the thousands
and hundreds to be specified. For example, to enter 15,000 revolutions, enter 150
on the large digits; to enter 8,500 revolutions, enter 085 on the large digits.
10.3 Preloaded codes (factory loaded)
Four factory-defined codes contain the wheel parameters as well as monitoring
parameters such as 'hours to oil change' and 'hours or km to service'. Only the
monitoring parameters can by altered at all times. Identification is obtained by high-
lighting a code number on the LCD display. The first code to be entered will be
0001.
The preloaded codes can only be altered by the manufacturer. It should be noted
that, if the instrument is reprogrammed, the total number of kilometres covered is set
to zero.
GB
95