Setting The Number Of Pulses Per Engine Revolution - Betamotor ALP4T 125 Bedienungsanleitung

1
20.4.3 Setting the number of
pulses per engine revolution (only
if requested)
The parameters can be entered manually
by attaching a transducer to connector
pin 12. If no tachometer is present, enter
00 on page 9 or page 10. This will pre-
vent the tachometer page from being dis-
played.
HALL rpm (number of pulses per engine
revolution)
Press and hold down the SCROLL but-
ton until the bars - - - - are displayed.
When the button is released, either 00
or the previously entered value is dis-
played. The value is updated and stored
using the same procedure described for
Figure 7. Pressing SCROLL for a short
time brings up Figure 10.
20.4.3.1 Setting the number of pulses
for the maximum rpm
The tachometer displays the number of
revolutions through 5 small digits and
the bar. To set the full-scale reading, it
is first necessary to enter the maximum
rpm.
max (number of pulses per engine revo-
lution)
Press and hold down the SCROLL but-
ton until the bars - - - - are displayed.
When the button is released, 000 will
be displayed in large digits and 00 on
small digits. The value is updated and
stored using the same procedure de-
scribed for Figure 7, bearing in mind that
100 stands for 10,000 rpm. Once the
value has been stored, the display will
appear as shown in Figure 10.
Pressing SCROLL for a short time brings
up Figure 11.
GB
Figure 9
Figure 10
Figure 11
100