Betamotor ALP4T 125 Bedienungsanleitung Seite 130

3
ENGINE OIL AND OIL FILTER ALP 125
Check
Keep the vehicle in an upright position.
The engine is cold, check for the presence
of oil.
Topping up
To restore the level, remove cap A and
top up.
Renewal
Always renew the oil when the engine is
hot. To avoid burns, take care not to touch
the engine and the oil.
• Put the vehicle on its stand.
• Extract the two screws D and fastening
E, and then remove protection C.
• Place a container under the engine.
• Unscrew filler plug A and drain plug B.
• Drain all the oil from the crankcase.
• Close plug B.
• Pour in 1000 cc of fresh oil.
• Screw on filler cap A again.
WARNING
Hot oil can cause severe burns.
Note:
Renew the engine oil after the first 500
km. For the renewal intervals, refer to the
table on page 142. Only use the
lubricants
recommended on page 123.
GB
A
E
D
B
130
C