Betamotor ALP4T 125 Bedienungsanleitung Seite 129

• Fit the oil filter cover after fitting the spring
and the O-ring, and then tighten the three
fastening nuts.
• Pour in the necessary quantity of oil.
• Close the filler plug and then refit the pro-
tection taking care to position the spacers
in sequence.
• Start the engine and allow it to idle for a
few minutes.
• Switch off the engine, wait for about a
minute, and then check the level. If nec-
essary top up without exceeding the max
level.
Engine oil capacity:
oil change ........................... 850 ml
with filter replacement ............ 950 ml
overhaul ........................... 1,300 ml
Note
Renew the oil after the first 1,000 km.
Subsequent renewals should be every
5,000 km 15 months, (refer to the table
on page 142). Always use the lubricants
shown on page 123.
The oil filter should be replaced for the first
time when the oil is first renewed, and sub-
sequently every 10,000 km (30 months).
Important
Dispose of used oil in compliance with the
regulations in force.
129
3
GB