Checking Codes; Entering Uncoded Values - Betamotor ALP4T 125 Bedienungsanleitung

1

20.3 Checking codes

The codes can be checked at all times. Perform the setup procedures again by
following the steps described in paragraph 20.1. Once the code has been selected
and stored, the display will appear as shown in Figure 5.
Press SCROLL until the horizontal bars shown in Figure 7 are displayed. Releasing
the button will display the wheel circumference corresponding to the selected code
(unmodifiable).
Briefly pressing the SCROLL button brings up Figure 6.
Press SCROLL until the horizontal bars shown in Figure 7 are displayed. Releasing
the button will display the wheel diameter corresponding to the selected code
(unmodifiable).
Briefly pressing the SCROLL button brings up Figure 8.
Press SCROLL until the horizontal bars shown in Figure 7 are displayed. Releasing
the button will display the number of pulses per wheel revolution corresponding to
the selected code (unmodifiable).
Briefly pressing the SCROLL button brings up Figure 9.
Press SCROLL until the horizontal bars are displayed. Releasing the button will
display the number of pulses per engine revolution corresponding to the selected
code (unmodifiable).
Briefly pressing the SCROLL button brings up Figure 10.
Press SCROLL until the horizontal bars are displayed. Releasing the button will
display the number of engine revolutions corresponding to the selected code
(unmodifiable).
Pressing SCROLL again will successively display figures 11, 12 and 13 which,
even though linked with the codes, can always be altered as described in para-
graph 20.4. At the end of the procedure, End appears on the display.
Pressing SCROLL for a short time while End is displayed returns to the menu, going
back to Figure 5.
Pressing SCROLL until the bars - - - - are displayed and then releasing it causes the
instrument to go into test mode as described in paragraph 40.0. The same result is
obtained by turning the instrument off and then on again.

20.4 Entering uncoded values

Figure 5
20.4.1 Setting Ln (wheel circumference)
or di (wheel diameter)
Ln (wheel circumference in mm): pressing
SCROLL for a short time changes to di
(wheel diameter in mm); pressing
SCROLL again changes back to Ln and
so forth. To be able to proceed, at least one
of the two values must be other than 0.
GB
98