Air Filter - Betamotor ALP4T 125 Bedienungsanleitung

3
D
A
C
GB
B
134

AIR FILTER

Follow these steps to gain access to the
air filter.
• Turn fastener D 90 degrees anti-
clockwise and remove the saddle by
pulling it towards the back of the vehicle.
• Remove side panel B after unscrewing
the screws shown in the figure.
• Take off plastic cover A after unscrewing
the 7 fixing screws, then follow these
steps:
• Unscrew the filter cover fixing screw
and remove filter C .
• Wash it with soap and water.
• Dry the filter.
•Wet the filter with filter oil. Remove
any excess lubricant to prevent it from
dripping.
• If necessary, also clean the inside of
the filter casing.
• Refit the parts, making sure of the seal
of the rubber gasket.
Note: If the filter is very dirty, first wash it
with a special detergent and then with
water and shampoo.
If the filter is damaged, immediately re-
place it.
WARNING:
After working on the filter, ensure that
nothing is left inside the filter casing.
Clean the filter every time the vehicle is
used off road.