Betamotor ALP4T 125 Bedienungsanleitung Seite 138

3
REMOVING THE BODYWORK
A
B B
To facilitate checks and operations in cer-
tain areas of the vehicle, it is essential to
remove the bodywork sections as de-
scribed below.
Removing the saddle
Remove the screw fixing the saddle to the
mudguard and then remove the saddle by
pushing it towards the rear of the vehicle
C
so as to disengage it from the hook on the
fuel tank.
Removing the carrier
Remove the three screws A fixing the car-
rier to the mudguard and then remove the
C
carrier.
Removing the side panel
After removing the air filter cover as de-
D
scribed in the chapter "Air Filter", unscrew
the four fixing screws B. One of the screws
is on the left side (under the filter box cover)
whereas the rear screw is located under-
neath the mudguard cover (not in view).
Removing the front side panels
E
Remove the six fixing screws C (three on
each side), two of which located under
the fuel tank, and then remove the front
side panels.
Removing the fuel tank
Remove screw D fixing the fuel tank to the
frame, detach the fuel cock line and then
remove the tank by pulling it towards the
F
rear of the vehicle.
Removing the headlight
Detach all the electrical connections and
unscrew the three fixing screws E, one of
which located under the headlight.
GB
138