Rear Brake - Betamotor ALP4T 125 Bedienungsanleitung

3
FRONT BRAKE
Check
To check the wear of the front brake, visu-
ally inspect the brake pad ends by look-
ing at the brake caliper from the front.
The brake linings should be at least 2
mm thick. If the linings are thinner, replace
the pads immediately.
Note
Carry out the check at the intervals shown
in the table on page 142.

REAR BRAKE

Check
To check the wear of the rear brake, visu-
ally inspect the brake pad ends by look-
ing at the brake caliper from above. The
brake linings should be at least 2 mm
thick. If the linings are thinner, replace
the pads immediately.
Note
Carry out the check at the intervals shown
in the table on page 142.
GB
136