Betamotor ALP4T 125 Bedienungsanleitung Seite 139

NOTES FOR TRIAL USE
If the vehicle is to be used over rough
ground, the customer may want to remove
the number-plate holder, the stand, the pas-
senger's footrests, replace the front sprocket
supplied with the kit, and fit backward-
shifted rider's footrests.
Replacing the rider's standard footrests with
backward-shifted footrests (trial)
• Remove the footrests from their supports
after unscrewing the M8 bolts.
• Remove the footrest supports by unscrew-
ing the Allen screws.
• Fit the trial footrest supports and then the
footrests by following the reverse proce-
dure to the removal.
Removing the number-plate holder
• Remove screw A fixing the number-plate
holder to the rear mudguard.
• Remove the three screws B fixing the
number-plate holder to the frame from the
lower part of the holder.
• Detach the rear light electrical connec-
tion and remove the number-plate holder.
Removing the stand
• Remove the stand switch by unscrewing
the only fixing screw C.
• Loosen the two screws D fixing the stand
support to the frame and then remove the
stand.
Removing the passenger's footrests
• Loosen the two screws E shown in the
figure and remove the passenger's foot-
rest complete with the frame fixing sup-
port.
A
D
E
139
3
B
C
GB