Betamotor ALP4T 125 Bedienungsanleitung Seite 120

1
ELECTRONIC CONTROL UNIT -
C
STARTING RELAY - VOLTAGE
REGULATOR
Control unit (C), starter relay switch (D)
and voltage regulator (E) are located
on the right side of the vehicle. To have
D
access to these components, remove the
saddle and the rear side panel as
described on page 138.
E
HV COIL
To gain access to coil (F), remove the
fuel tank as described on page 138.
F
FUSE - FLASHER UNIT - STAND RELAY
Flasher unit (G), stand relay (H) and fuse
box (I) are installed under the control
unit. To replace any of these
components, remove the saddle and the
rear side panel as described on page
138, then disengage control unit (C)
from its rubber support.
G
H
I
GB
120