Adjusting The Transparency Of The On-Screen Display - G&D DP1.2-Vision-IP-Series Installation Und Bedienung

Configuration

Adjusting the transparency of the on-screen display

In the default settings of the KVM switch, the on-screen display covers parts of the
screen content. However, the parts of the screen contents covered by the OSD are
still visible.
You can adjust the transparency level or turn the transparency off.
How to adjust the transparency of the on-screen display:
1. Press Ctrl+Num
2. Select the row
3. Select the row
4. Under
OSD transparency
 high transparency of the screen content
high
 average transparency of the screen content (default)
average
low  low transparency of the screen content
off  screen content is covered
5. Press to save your settings.
F2
1. Click on
IP Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tabs
4. Under
OSD transparency
 high transparency of the screen content
high
 average transparency of the screen content (default)
average
 low transparency of the screen content
low
 screen content is covered
off
5. Click to save your changes.
OK
57 · G&D DP1.2-Vision-IP-Fiber
(default) to open the on-screen display.
Console setup and press
and press
Personal Profile
press to select on of the following options:
F8
Remote > Extender system > Personal profile
select one of the following options:
Enter .
.
Enter
on the directory tree.
.