Configuring A Kvm-Over-Ip Connection Of A Computer Module - G&D DP1.2-Vision-IP-Series Installation Und Bedienung

Establishing a KVM-over-IP™ connection for the first time
DEFAULT SETTING OF THE USER MODULE (CON)
IP address:
Netmask
Local control port:
Local communication port:
Local data port:
Remote host:
Remote control port:
NOTE:
The IP address
computer module must be specified to establish a
the user module.
The configuration of both the
cally exchanged between the two modules.
Configuring a KVM-over-IP connection of a computer
module
You can carry out the required configuration settings directly on the console.
NOTE: Use the
local hotkey
the network interface of the user module, or use the
+ ) to open the remote OSD to configure the network interface of the com-
Ctrl Num
puter module.
The settings of both hotkeys are shown during the starting process of the user
module (see Starting process on page 13).
IMPORTANT:
The OSD of the computer module can be opened only if a
connection to the computer module is established.
Therefore, you have to change the configuration of the computer module first.
15 · G&D DP1.2-Vision-IP-Fiber
172.17.0.11
255.255.0.0
18246
18245
18244
172.17.0.10
18246
of the computer module (host) as well as the
communication ports
(default: +
Alt
KVM-over-IP
and the
) to open the local OSD to configure
Num
control port of the
connection through
are automati-
data ports
(default:
remote hotkey
KVM-over-IP