Changing The Scancode Set Of Ps/2 Keyboards - G&D DP1.2-Vision-IP-Series Installation Und Bedienung

Changing the scancode set of PS/2 keyboards

If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
Use the scancode set 3 if you cannot enter the pipe "|" or the arrow keys do not
work as expected.
How to change the setting of the scancode set:
1. Press Ctrl+Num
2. Select the row
code set of the remote console (at the
Select the row
scancode set of the local console (at the
3. Under Scancode set
2  activates scancode set 2 for PS/2 keyboard inputs
3  activates scancode set 3 for PS/2 keyboard inputs
4. Press F2 to save your settings.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
1. Click on
IP Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tab
sole (at the CPU
Click on the tab
the remote console (at the
4. Under Scancode set
activates scancode set 2 for PS/2 keyboard inputs
Set 2
Set 3 activates scancode set 3 for PS/2 keyboard inputs
5. Click OK to save your changes.
6. Turn the KVM extender off and on again.
After you turn the KVM extender on again, the keyboard is initialised and the
selected scancode set is applied.
(default) to open the on-screen display.
and press
Console setup
Local console setup and press
press F8 to select one of the following options:
on the directory tree.
if you want to adjust the screensaver of the local con-
Local
module).
if you want to adjust the scancode set of
Remote > General
CON module).
select one of the following options:
if you want to adjust the scan-
Enter
CON module).
Enter if you want to adjust the
CPU module).
G&D DP1.2-Vision-IP-Fiber · 50
Configuration