Adjusting The Transparency Of The On-Screen Display - G&D DL-DVI-Vision-IP-Series Installation Und Bedienung

Adjusting the transparency of the on-screen display

In the default settings of the KVM switch, the on-screen display covers parts of the
screen content. However, the parts of the screen contents covered by the OSD are
still visible.
You can adjust the transparency level or turn the transparency off.
How to adjust the transparency of the on-screen display:
1. Press Ctrl+Num
2. Select the row
3. Select the row
4. Under
OSD transparency
 high transparency of the screen content
high
average  average transparency of the screen content (default)
low  low transparency of the screen content
 screen content is covered
off
5. Press to save your settings.
F2
1. Click on IP Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tabs
4. Under
OSD transparency
 high transparency of the screen content
high
average  average transparency of the screen content (default)
low  low transparency of the screen content
 screen content is covered
off
5. Click to save your changes.
OK
(default) to open the on-screen display.
Console setup and press
Personal Profile and press
press to select on of the following options:
F8
on the directory tree.
Remote > Extender system > Personal profile
select one of the following options:
Enter .
Enter .
.
G&D DL-DVI-Vision-IP-Fiber · 54
Configuration