G&D DP1.2-Vision-IP-Series Installation Und Bedienung Seite 122

Configuration
How to configure the Freeze mode:
1. Press
Ctrl+Num
2. Select the row
The Freeze mode is adjusted separately for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
3. Under Freeze mode
off  Freeze mode is disabled (default)
on  Freeze mode is enabled
4. If the Freeze mode is active, press
under Freeze visualization
frame
OSD
frame+OSD
5. Press F2 to save your settings.
1. Click on IP Extenders > [All Extenders]
2. Double-click the computer module of the KVM extender you want to con-
figure.
3. Click on the tabs
The Freeze mode is adjusted separately for each video channel of the user module. The
following options can be adjusted separately for each video channel of multi-channel
devices.
4. Under Freeze mode
(default)
Disabled
Enabled
5. If the Freeze mode is active, additionally select one or both options available
under Freeze visualization
Frame
OSD
6. Click to save your changes.
OK
43 · G&D DP1.2-Vision-IP-Fiber
(default) to open the on-screen display.
Console setup and press
press F8 to select on of the following options:
:
 shows a coloured frame when disconnected
 shows Frozen and the time passed since disconnection
 shows a coloured frame (
Remote > General
select one of the following options (see above):
:
 shows a coloured frame when disconnected
 shows Frozen and the time passed since disconnection
Enter .
F8 to select one of the options available
frame ) and Frozen (
on the directory tree.
.
OSD )