Changing The Scancode Set Of Ps/2 Keyboards - G&D DL-DVI-Vision-CAT Installation Und Bedienung

The multimedia controller
 Controller:
and video programs. A special USB keyboard mode lets you use the controller to
operate the computer connected to the target module:
INPUT DEVICE
Contour ShuttlePRO v2
 LK463 compatible keyboard:
suer modules of the KVM matrix switch. The order of the 108 keys of these keyboards
corresponds to the OpenVMS keyboard layout.
A special USB keyboard mode guarantees that whenever a special key of this key-
board pressed, this action is transmitted to the target computer:
INPUT DEVICE
LK463 compatible keyboard
How to select a USB-HID mode:
1. Press Ctrl+Num
2. Select the row
3. Select the row
4. Press to save your settings.
F2
1. In the menu, click on
2. Click on the KVM extender you want to configure and then click
on Configuration
3. Click on the tab
4. Select the desired option (see above) under
5. Click on
Save

Changing the scancode set of PS/2 keyboards

If you press a key at the PS/2 keyboard, the keyboard processor sends a data packet
that is called scan code. The two common scancode sets (sets 2 and 3) contain differ-
ent scancodes.
In the default configuration, the KVM extender interprets any entry made at the
PS/2 keyboard with the scancode set 2.
ShuttlePRO v2
You can connect an LK463 compatible keyboard to the
(default) to open the on-screen display.
Target setup and press
USB HID mode and press
KVM extender .
.
General and then on the tab
.
is used to operate various audio
SETTING
 Contour SP2
SETTING
 LK463
Enter .
F8 key to select an option (see above).
CPU .
USB HID mode .
G&D DL-DVI-Vision-CAT · 38
Configuration