Herunterladen Inhalt Inhalt Diese Seite drucken

Removing The Fabric Cover - BabySafe Golden Bedienungsanleitung

Inhaltsverzeichnis

Werbung

– Then from the front of the child seat, pull out shoulder belt through the slots.
– Pull below both,the shoulder pads and the belts to the front through the slots.
(Front side of the child seat).
– Remove the shoulder pads from the shoulder belts and put them in the storage
eat, pull out
bag. 6.5.7 Roll the shoulder belts and place them separately on both side into the
fabric cover from the slot of fabric.
s and the
ont side of the
he shoulder
them
cover from
6.5.8 Grasp the metal plate from underneath and
turn it into a vertical position.Push upwards and
slide the metal plate through the slot.
6.5.9 Remove the harness buckle with the crotch
pad and store it in the storage bag.
– Grasp the metal plate from underneath and turn it into a vertical position.Push
upwards and slide the metal plate through the slot.
– Remove the harness buckle with the crotch pad and store it in the storage bag.
instruction
46

6.6 Removing the fabric cover

6.6.1 Removing the cover of the headrest
A) Removing the 5-point harness
Take off the cover from backrest and base.
B) Headrest
1. Move the headrest of the child seat to the upper position.
2. Take off the cover from belt holder of headrest first,then remove the cover of the
headrest.
6.6.2 Re-fitting the Cover Simply follow the steps in the opposite way.
CAUTION! Never use the child seat in installation without a correct installed
buckle. Make sure that the metal plate is correctly attached.
CAUTION! Check that the harness straps are not twisted and that they have been
correctly inserted in the belt slots on the cover.
6.7 Adjust the angle of child safety car seat There has 4-level adjustment in the child
safety car seat.
6.6 Removing the fabric cover
Before fixing a child in the child restraint system,the seat must be set on the recline
position for rear-facing use,see picture or in the siting position for forward-facing
6.6.1 Removing the cover of the headrest
use, see picture
A) Removing the 5-point harness
To achieve that,use the recline handle located in front of the child restraint system
Take off the cover from backrest and base.
between the sitting part and the base to adjust the desired position.
B) Headrest
1. Move the headrest of the child seat to the upper
position.
2. Take off the cover from belt holder of headrest
first,then remove the cover of the headrest.
6.6.2 Re-fitting the Cover
Simply follow the steps in the opposite way.
CAUTION!
Never use the child seat in installation
without a correct installed buckle.
Make sure that the metal plate is correctly attached.
CAUTION!
Check that the harness straps are not
twisted and that they have been correctly inserted in
the belt slots on the cover.
instruction
6.7 Adjust the angle of child safety c
There has 4-level adjustment in the c
safety car seat.
Before fixing a child in the child restr
system,the seat must be set on the r
position for rear-facing use,see pictu
the siting position for forward-facing
picture①②③
To achieve that,use the recline hand
located in front of the child restraint
between the sitting part and the bas
adjust the desired position.
Total has four level positions:
①first level ②second level
③third level ④ the fourth level
47

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis