Replace Batteries; Storage And Cleaning - Braun VitalScan BBP 2000 Bedienungsanleitung

Replace batteries

1. Open the battery compartment on the left side by
pulling battery door down.
2. Replace the batteries – ensure they are
correctly connected, as shown on the symbols
in the compartment.
3. All saved memories are retained although date and
time must be reset—the year number therefore fl ashes
automatically after the batteries are replaced.
To set time and date, follow the procedure described
in Time and date on page 4.
Cuff fitting
1. Remove all objects and jewelry from the wrist
(e.g. wristwatch, bracelet, etc.) Put the cuff over the
wrist in with the monitor face on the INSIDE of wrist.
2. The distance between the cuff and the hand
should be approximately 2 cm (1/2").
3. Secure the cuff with the Velcro fastener, so that it
lies comfortably and not too tight. No space should
remain between the cuff and the wrist.
10

Storage and cleaning

1
• Do not expose device to either extreme temperatures,
humidity, dust or direct sunlight.
• The cuff contains a sensitive air-tight bubble.
Handle this carefully and avoid all types of straining
through twisting or buckling.
2
• Clean the product with a soft, slightly damp cloth.
Stains on the cuff can be carefully removed with a
damp cloth. Do not use gasoline, thinners or similar
solvents. Do not wash or dry clean the cuff . Do not
store the product in a place exposed to direct sunlight
3
or high humidity.
• Do not drop the device or treat it roughly in any way.
Avoid strong vibrations.
• NEVER open the device! This will make the
manufacturers warranty invalid!
2 cm
Calibration
This product has been calibrated at the time of manufacture. If used according to
the use instructions, periodic recalibration is not required. If at any time, you
question the measuring accuracy, please contact an authorized Service Centre .
3.
11