Battery Charge Indicator - Braun VitalScan BBP 2000 Bedienungsanleitung

Average & memory functions
Your VitalScan 3 blood pressure monitor will automatically store 90 measurements
(VitalScan 1 model: 10 measurements). Storing is done automatically after each
completed measurement. The memory is nonvolatile. This means that you will not lose
stored data when changing batteries. However, the memory can be cleared manually.
See Deleting all measurements on page 9.
The VitalScan 3 model features an Average function to display the average
reading of the last three measurements.
Note: Average readings feature is NOT available in the VitalScan 1 model.
Recalling average readings (VitalScan 3 only)
1. To recall average readings, press
The average of the 3 last readings will display
along with average icon .
2. To exit, turn device off by pressing
Recalling stored readings (VitalScan 1 and VitalScan 3)
1
1. Press memory button once for average of existing memories (this step is for
VitalScan 3 only. See Recalling average readings above.) Then press
again. Memory icon will appear and a number will briefl y appear in the
pulse fi eld. This number indicates which memory is being recalled. Then, the
recalled measurement will display.
2. Repeatedly pressing the button will call up one by one all stored readings.
The number of the memory will appear fi rst, followed by the measurement.
3. To exit the memory mode, press the
8
button.
button.
2
button.
Deleting all measurements
IMPORTANT: Before proceeding to clear all the memory, make sure you don't have
to make reference to the readings in the future.
1
7 Sec.
3.
1. In shut off mode, press
in display.
2. When you release the
3. Press the
disappear which indicates all stored readings have been deleted.

Battery charge indicator

Batteries almost discharged
When the batteries are approximately 75% used the
battery symbol will fl ash. The monitor will continue to
measure reliably, but new batteries should be obtained.
Batteries discharged—replacements required
! When the batteries are dead, the battery symbol
will fl ash empty, display will go blank and 3 beeps will
sound. You cannot take any further measurements
button
and must replace the batteries.
2
button for at least 7 seconds until CL appears
button, CL will fl ash.
button one more time and 3 short beeps will sound, CL will
3
!
9