Logging On And Off Per Radio Code - RADEMACHER 3500 08 64 Betriebsanleitung

i
11. Logging DuoFern transmitters on/off
4. If log-on/log-off is successful, the status LED will light up
green and the drive starts up briefly by way of confirmation.
5. Register the next DuoFern transmitter. In order to do so,
repeat steps 1 to 3, or else terminate registration.
NOTE
The status LED lights up red if the registration process fails, for
example if:
◆ 20 DuoFern transmitters have already been registered.
◆ an attempt is made to register an unsuitable device (e. g. other
DuoFern actuator).
◆ an attempt is made to log-off a DuoFern transmitter that is not
logged-on.
i
12. Logging on and off per radio code
You can control the DuoFern Connect actuator directly using the radio
code in order, for example, to be able to connect further DuoFern
transmitters to the actuator after installation. The radio code is pro-
vided from factory in the form of a label attached to the actuator.
NOTE
A corresponding transmitter is required (e.g. DuoFern manual central
operating unit, item no. 3481 00 60 or HomePilot, item no. 3400 08
19) in order to use the radio code.
A more detailed description of the login/log-off process via the radio
code can be found in the respective operating instructions for both
devices.
The radio code is only active for 120 minutes after switching on the
power supply. For this reason, it may be necessary to briefly interrupt
the power supply, in order to be able to use the radio code.
EN
43