Siemens SINUMERIK 802C Inbetriebnahme Seite 99

36130 POS_LIMIT_PLUS2
mm, 2nd software limit switch plus
Grad
_always 100000000
36200 AX_VELO_LIMIT
mm/min, Threshold value for velocity monitoring
Umdr/min (control parameter set no.): 0...5
_always 11500., 11500., 11500.,
11500., ...
36300 ENC_FREQ_LIMIT
Hz Encoder limit frequency
_always 300000
36302 ENC_FREQ_LIMIT_LOW
% Encoder limit frequency at which encoder is switched on again. (Hysteresis)
_always 99.9
36310 ENC_ZERO_MONITORING
- Zero mark monitoring (encoder no.): 0,1
0: Zero mark monitoring off, encoder HW monitoring on
1-99, >100: Number of recognized zero mark errors during monitoring
100: Zero mark monitoring off, encoder HW monitoring off
_always 0, 0
36400 CONTOU_TOL
mm, Grd Toleranzband Konturüberwachung
_always 1.0
36500 ENC_CHANGE_TOL
mm, Grd portion of distance for backlash working
_always 0,1
36610 AX_EMERGENCY_STOP_TIME
s Duration of the deceleration ramp for error states
_always 0.05
36620 SERVO_DISABLE_DELAY_TIME
s Cutout delay servo enable
_always 0.1
36700 DRIFT_ENABLE
- Automatic drift compensation
_always 0
36710 DRIFT_LIMIT
% Drift limit value for automatic drift compensation
_always 1.000
36720 DRIFT_VALUE
% Drift basic value
_always 0.0
38000 MM_ENC_COMP_MAX_POINTS
- Number of intermediate points for interpolatory compensation (SRAM)
_always 0, 0
SINUMERIK 802C
6FC5 597-3AA20-0AP2 (01.02) (IBN)
6.1 Liste der Maschinen- und Settingdaten
- -
0.0 plus
0 plus
0 100
0.0 plus
*** ***
0.0 plus
0.0 plus
0.0 plus
*** ***
0.0 plus
0 5000
Technischer Anhang
RESET
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
POWER ON
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
NEW CONF
DWORD 2/7
NEW CONF
DOUBLE 2/2
NEW CONF
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
NEW CONF
BOOLEAN 2/7
NEW CONF
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
POWER ON
DWORD 2/7
6-99