Siemens SINUMERIK 802C Inbetriebnahme Seite 97

35150 SPIND_DES_VELO_TOL
Faktor Spindle speed tolerance
_always 0.1
35160 SPIND_EXTERN_VELO_LIMIT
Umdr/min Spindle speed limitation from PLC
_always 1000
35200 GEAR_STEP_SPEEDCTRL_ACCEL
Umdr/s^2 Acceleration in speed control mode [gear stage no.]: 0...5
_always 30, 30, 25, 20, 15, 10
35210 GEAR_STEP_POSCTRL_ACCEL
Umdr/s^2 Acceleration in position control mode (gear stage no.): 1...5
_always 30, 30, 25, 20, 15, 10
35220 ACCEL_REDUCTION_SPEED_POINT
Faktor Speed for reduced acceleration
_always 1.0
35230 ACCEL_REDUCTION_FACTOR
Faktor Reduced acceleration
_always 0.0
35240 ACCEL_TYPE_DRIVE
- Type of acceleration
0
35300 SPIND_POSCTRL_VELO
Umdr/min Position control switch-on speed
_always 500
35350 SPIND_POSITIONING_DIR
- Direction of rotation when positioning
_always 3
35400 SPIND_OSCILL_DES_VELO
Umdr/ Reciprocation speed
min
_always 500
35410 SPIND_OSCILL_ACCEL
Umdr/ Acceleration during reciprocating
s^2
_always 16
35430 SPIND_OSCILL_START_DIR
- Starting direction during reciprocation
0-2: As last direction of rotation (zero-speed M3)
3: M3 direction
4: M4 direction
_always 0
35440 SPIND_OSCILL_TIME_CW
s Reciprocation time for M3 direction
_always 1.0
SINUMERIK 802C
6FC5 597-3AA20-0AP2 (01.02) (IBN)
6.1 Liste der Maschinen- und Settingdaten
0.0 1.0
0.0 plus
2 ***
2 ***
0.0 1.0
0.0 0.95
0 1
0.0 plus
3 4
0.0 plus
2 ***
0 4
0.0 plus
Technischer Anhang
RESET
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
RESET
DOUBLE 2/7
RESET
DOUBLE 2/7
RESET
BOOLEAN 2/7
NEW CONF
DOUBLE 2/7
RESET
BYTE 2/7
NEW CONF
DOUBLE 2/7
NEW CONF
DOUBLE 2/7
RESET
BYTE 2/7
NEW CONF
DOUBLE 2/7
6-97