Siemens SINUMERIK 802C Inbetriebnahme Seite 74

Inbetriebnahme (IBN)
4.7 Erst-Inbetriebnahme
Num-
mer
36050 Clamping tolerance
(nur bei
SPOS)
Maximum velocity/speed "axis/spindle stopped"
36060
(nur bei
SPOS)
Threshold value for velocity monitoring (control parameter set no.): 0...5
36200
36300 Encoder limit frequency
Encoder limit frequency at which encoder is switched on again. (Hystere-
36302
sis)
Zero mark monitoring (encoder no.):
0,1 0:
36310
1-99, >100: Number of recognized zero mark errors
100:
36400 Contour Tol
36610 Duration of the deceleration ramp for error states
36620 Cutout delay servo enable
36700 Automatic drift compensation
36710 Drift limit value for automatic drift compensation
36720 Drift basic value
Geberanpassung an Achse bzw. Spindel
Maschinendaten für Geberanpassung
Num-
mer
31040 Encoder mounted directly to the machine
Encoder markings per revolution
31020
31080 Numerator resolver gearbox
31070 Denominator resolver gearbox
31060 Numerator load gearbox (control parameter set no.): 0...5
31050 Denominator load gearbox (control parameter no.): 0...5
4-74
Erklärung
Zero mark monitoring off, encoder
HW monitoring on
during monitoring
Zero mark monitoring off, encoder
HW monitoring off
Erklärung
Standard-
wert
0.5
5 (Achse);
0,0138
(Spindel)
11500
(Achse);
31,94 (Spin-
del)
300000
99.9
0.05
0.1
Spindel
0
Striche / Striche /
Umdr. Umdr.
Motorumdr. Lastumdr.
Geberumdr. Geberumdr.
Motorumdr. Motorumdr.
Lastumdr.
Lastumdr.
SINUMERIK 802C
6FC5 597-3AA20-0AP2 (01.02) (IBN)
0
1
0
1
0
1