KEB COMBIVERT Einbauanleitung Seite 31

Preparing for Installation
• Pull cover fixings (5) upwards and remove cover (6)
• if the operator is screwed, loosen the screws (9)
• Solve operator (4) pull upwards
• Solve screws (7) and remove carrier plate (3)
• Unscrew screws (2) from the distance pins (included distance pins are not required for
devices with functional safety. These must be mounted first for other devices).
Installation of the interface board
• Plug the plug connector of the interface board (1) into the socket connector of the control
(8) and press on firmly
• Screw the interface board (1) with the screws (2) to the distance pin and tighten it with
0.7 Nm
• Attach the carrier plate (3) and tighten screws (7) with 1.3 Nm
• Plug on operator (4)
• if the operator is screwed, re-tighten the screws (9)
• Attach the cover (6) and press down the cover fixings (5) to the latch
• Fill out the return form from chapter 4 and send it back
Mechanical installation
GB -15