Figure 4; Installation Of The Interface Board Housing G And H - KEB COMBIVERT Einbauanleitung
Geberschnittstellen mit sicherheitsfunktion sto f5-k/ -l/ -p
Vorschau ausblenden
Andere Handbücher für COMBIVERT:
- Applikationsanleitung (162 Seiten) ,
- Anleitung (124 Seiten) ,
- Bedienungsanleitung (54 Seiten)
Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.2.2
Installation of the interface board
1 Cut-outs for cover fixing
2 Screws M2.5 x 6
3 Interface board
Figure 4:
Installation of the interface board
•
Plug the plug connector of the interface board (3) into the socket connector of the control
and press on firmly
•
Screw the interface board (3) with the screws (2) to the distance pin and tighten it with
0.7 Nm
•
Hook cover (4) into the cut-outs (6) and then press down until the latch engages into the
cut-outs (1)
•
Slip on operator (5)
•
Fill out the return form from chapter 4 and send it back
4
3
2
1
Installation of the interface board housing G and H
Mechanical installation
5
4 Cover
5 Operator
6 Cut-outs for cover fixing
6
GB -13
Werbung
Kapitel
Inhaltsverzeichnis
