Www.walther-Pilot.de • Email:info@Walther-Pilot.de; Identification Of Model Version; Kärntner Str. 18-30 • D-42327 Wuppertal; Normal Use - WALTHER PILOT PILOT Maxi-HD Betriebsanleitung

Contents
1 General
1.1

Identification of model version

1.2

Normal use

1.3 Improper use
2 Technical description
3 General safety instructions
4 Connection of input lines
5 Operational handling
6 Adjusting the spray pattern
6.1 Correction of spray pattern
7 Trouble shooting
8 Retooling and repairs
9 Cleaning
10 Disposal of cleaning and servicing substances
11 Technical data
1 General
1.1 Identification of model version
Models: Manual spray guns PILOT Maxi-HD / MD / ND
Type: PILOT Maxi-HD
PILOT Maxi-HD
PILOT Maxi-HD
PILOT Maxi-MD
PILOT Maxi-MD
PILOT Maxi-MD
PILOT Maxi-ND
PILOT Maxi-ND
PILOT Maxi-ND
PILOT Maxi-HD-K Material connection
PILOT Maxi-HD-K Gravity-feed cup
PILOT Maxi-ND-K Material connection
PILOT Maxi-ND-K Suspended pressure cup
PILOT Maxi-ND-K Gravity-feed cup
Manufacturer: WALTHER Spritz- und Lackiersysteme GmbH

Kärntner Str. 18-30 • D-42327 Wuppertal

Phone: 00 49 / 2 02 / 787-0 • Telefax: 00 49 / 2 02 / 787-217

www.walther-pilot.de • Email:info@walther-pilot.de

1.2 Normal use
The manual spray guns of the series PILOT Maxi-HD / MD / ND are designed to
be used exclusively for sprayable media, such as:
• paints and lacquers
• greases, oils and corrosion preventives
• ceramic glazes
• stains
• adhesives (only PILOT Maxi-K-versions)
Since all wetted parts are made of stainless specialty steel, the spray guns can
also be used for spraying aqueous materials.
If the material you intend to spray is not included in the above list, please contact
WALTHER Spritz- und Lackiersysteme GmbH, Wuppertal, for further information.
Please note that sprayable materials may only be applied to workpieces and/or
similar objects. The spray gun models PILOT Maxi-HD-K and PILOT Maxi-ND-K
are specially designed for use with adhesive coatings. The model PILOT Maxi-HD-
K is made for solvent adhesive and the model PILOT Maxi-ND-K is made for
dispersion coating. All media-supplying parts are made of stainless special steel.
The temperature of the spraying material must not exceed 43 °C.
The term "normal use" also implies that all safety warnings, operating handling
details, etc., as stated in these operating instructions are carefully read, under-
stood and duly complied with.
Gravity-feed cup V 11 613
Material connection V 11 614
Suction cup V 11 619
Gravity-feed cup V 11 615
Material connection V 11 616
Suspended pressure cup V 11 617
Gravity-feed cup V 11 633
Material connection V 11 634
Suspended pressure cup V 11 635
V 11 618
V 11 626
V 11 620
V 11 622
V 11 623
2