Ymbols Used; In The Documentation; Warning Notices - Structure And Meaning; Symbols In This Documentation - Bosch FSA 050 Betriebsanleitung

1. Symbols used
1.1

In the documentation

1.1.1 Warning notices - �tructure and meaning
Warning notices indicate hazards and their consequen-
ces for the user or surrounding persons. Warning noti-
ces also describe the measures for preventing these
hazards. The signal word has a crucial importance. It
indicates the probability of occurrence and the severity
of the hazard in case of non-compliance:
�ignal Probability of
word occurrence
DANGER Immediate impend-
ing danger
WARNING Possible impending
danger
CAUTION Possible dangerous
situation
Below you will see an example of the "Live parts"
warning notice by way of example, with the signal word
DANGER:
DANGER – Exposure of live parts on ope-
ning the ��A ���!
Risk of (fatal) injury or heart failure from elec-
tric shocks on contact with live components.
¶
Work on electrical installations or equip-
ment is only to be performed by qualified
electricians or trained personnel under the
guidance and supervision of an electrician.
¶
Disconnect FSA 050 from the mains be-
fore opening.
1.1.2 �ymbols in this documentation
�ym- Designation Explanation
bol
Attention Warns about possible property damage.
!
Information Practical hints and other
i
useful information.
1. Multi-step Instruction consisting of several steps
2. operation
One-step Instruction consisting of one step.
e
operation
Intermediate An instruction produces a visible inter-

result mediate result.
Final result There is a visible final result on comple-
"
tion of the instruction.
Robert Bosch GmbH
�everity of danger if in-
structions not observed
Death or severe injury
Death or severe injury
Minor injury
�ymbols used | ��A ��� | 21
1.2

On the product

!
Observe all warning notices on products and ensure
they remain legible!
�ymbols on the battery cover
�ymbol Description
Danger: Avoid contact with live parts.
This symbol appears on the LCD during insulation ana-
lysis to warn users of hazardous voltage at the measu-
rement leads. Always wait until the voltage has been
discharged down to a safe level.
Never exceed the interference voltage detection limit
value.
Devices fully protected by double insulation (class II).
Devices which satisfy the relevant EC directives.
Devices which satisfy "C mark" requirements.
Maximum input voltage 600 V TRMS
not >
600 V
Disposal
Dispose of used electrical and electronic
devices, including cables, accessories and
batteries, separately from household waste.
en
|
1 689 989 102 2011-04-26