Lcd; Battery Charge Indicator; Defective Fuse Symbol; Bluetooth Usb Adapter - Bosch FSA 050 Betriebsanleitung

en 26 | ��A ��� | Product description
4.�

LCD

1 2
14
13
12
11
10
Fig. 5: LCD
1 Continuity measurement symbol
2 Digital auxiliary display
3 Auxiliary display units
4 Buzzer on
5 Battery charge indicator
6 Analog display
7 TRMS symbol (AC)
8 Main display units
9 Digital main display for measured value and status (FSA/STA)
10 Symbol for zeroing of measurement leads
11 Range overshoot symbol
12 Defective fuse symbol
13 Insulation analysis symbol (test voltage applied)
14 Lock symbol (insulation analysis)
4.6

Battery charge indicator

The current charge of the batteries is always indicated
on the LCD (Fig. 5, Pos. 5). The number of bars shows
the charge of the batteries in percent (Fig. 6).
Fig. 6: Battery charge
i
Rechargeable NiMH or NiCAD batteries indicate a
lower charge than alkaline cell batteries. As a result,
the charge indicator may abruptly switch to 0 % just
before becoming flat.
|
1 689 989 102 2011-04-26
3 4
5
6
7
459896-07_Ko
9
4.7

Defective fuse symbol

!
The fuse in the FSA 050 must always have the cor-
rect rating – 500 mA (FF).
The defective fuse symbol (Fig. 5, Pos. 12) flashes on
the LCD if the internal fuse of the FSA 050 has blown
due to overload.
The fuse rating is indicated on the rating plate of the
FSA 050.
8
4.8 Bluetooth U�B adapter
Only the Bluetooth USB adapter included in the scope
of delivery provides a radio link with the FSA 500/
FSA 7xx. It is plugged in at the PC/Laptop. Readiness
for operation is indicated by the flashing blue LED.
i
It is not possible to operate any other Bluetooth
hardware fitted in or plugged into the PC/Laptop.
i
The Bluetooth driver is installed if the menu item
"Use ��A ���" is selected in the CompacSoft[plus]
software under "�ettings" and confirmed with <�7>
or <�12>. The FSA 050 MAC address is printed under
the protective rubber on the reverse side of the
device.
i
With a Bluetooth communication,
Pos. 2) on the LCD display for approx. one second
after pressing the selection button  (Fig. 3, Pos. 4).
!
Do not subject the Bluetooth USB adapter connec-
ted to the Laptop to mechanical strain or use it as
a handle, as this could damage the Laptop or Blue-
tooth USB adapter.
appears (Fig. 5,
bt
Robert Bosch GmbH