C) Setting Of Tooth Backlash - Reely ROAD Sports Car Bedienungsanleitung

c) Setting of tooth backlash

Control the tooth backlash at regular intervals. The tooth backlash has to be adjusted at the latest when the electric
motor, the motor pinion or the main pinion is exchanged.
To do this loosen the two fastening screws (1) of the electric
motor so that you can move the motor (2) with slight pres-
sure in the direction of the main pinion (3). 5
3
Motor pinion (4) and the main pinion now engage into each
other without tolerance.
2
Now take a narrow paper strip (5) and place it on the top
between the toothed wheels.
4
1
Now move the main pinion by hand so that the paper strip
between the two toothed wheels is pulled in.
Figure 19
The pressure of the paper pushes back the electric motor by the degree necessary. Now fasten the fastening screws
of the motor again in this position. When you turn back the main pinion afterwards so that the paper strip can be taken
out again, both toothed wheels will have the necessary distance to each other.
43