M) Setting Display Unit For Temperature (°C/°F); N) Switching Backlighting On/Off - Conrad 67 23 31 Bedienungsanleitung

Stopping alarm signal or snooze function (SNOOZE)
• If a sound signal is output at the set alarm time, you can terminate it by briefly pressing the
button "<", "MODE" or ">".

The alarm signal is automatically terminated after approx. 1 minute and only
triggered again on the next day.
• You may also activate the snooze function. The alarm signal will then be interrupted for about
1 minutes and then restarted.
For this, press the top of the weather
station to trigger the button integrated
into the base (5) (also see figure in
chapter 8. a).
When the snooze function is active,
the symbol " " flashes in the dis-
play.
To prematurely terminate the snooze
function, briefly press the button "<",
"MODE", or ">".
m) Setting Display Unit for Temperature (°C/°F)
This function selects whether the temperature values in the weather station display are
displayed with the temperature unit "°C" (degrees Celsius) or "°F" (degrees Fahrenheit).
To switch between the two units, briefly press the button "C/F SEARCH" at the bottom of the
weather station.

n) Switching Backlighting On/Off

• The display being permanently lit may be an interference in the night. Briefly press the button
"LIGHT ON/OFF" at the bottom of the weather station to switch the backlighting on or off
permanently.
• If the backlighting is off and you want to check the time, e.g. at night, briefly press the top of
the weather station to trigger the button integrated into the base (5) (also see figure in chapter
8. a).
Then the backlighting is activated and goes out automatically after 15 seconds.
52
5