F) Displaying Max/Min Values; G) Deleting Max/Min Values; H) Displaying Dew Point - Conrad 67 23 31 Bedienungsanleitung

f) Displaying MAX/MIN Values

Maximum and minimum values for temperature and humidity can be displayed for every
sensor (indoor or outdoor sensor).
• Select the desired sensor with the buttons "<" (2) and ">" (4) first.
• Then press the button "MEM" on the bottom of the weather station repeatedly to switch
between maximum values (display "MAX" in the LC display), minimum values ("MIN") and
current measured values.

g) Deleting MAX/MIN Values

• Select the desired sensor with the buttons "<" (2) and ">" (4) first.
• Briefly press the button "MEM" on the bottom of the weather station so that either the
maximum values (display "MAX" in the LC display), or the minimum values ("MIN") are
displayed.
• Then keep the button "MEM" on the bottom of the weather station pressed for approx.
3 seconds. Then the maximum and minimum values are reset to the current measured
values.

h) Displaying Dew Point

The dew point is a temperature point that depends on the correspondence of a certain
barometric pressure, a certain temperature and a certain humidity.
At this temperature point, humidity in the air starts to condensate, which is called dewing.
Humidity condensates and precipitates and liquid (mist, vapour).
If the dew point for steam is below 0 °C, condensation occurs as slow or hoarfrost.
The weather station can calculate and display this temperature.
Proceed as follows:
• Select the desired sensor with the buttons "<" (2) and ">" (4) first.
• Press the button "MODE" (3) repeatedly until "DEW POINT" is displayed at the lower left of
the display. The temperature value displayed now is the dew point.
49