14.
Technical Data of the Vehicle
Scale: ........................................................ 1:10
Driving battery suitable for the vehicle ..... NiMH battery pack with 6 cells (rated voltage 7.2 V) or
The speed controller is pre-set for a NiMH/ battery with 6 cells. If you want to connect a 2-cell LiPo battery,
you have to reprogram the speed controller with the optionally available programming card! Only then will
the undervoltage protection for LiPo-batteries (3.0 V per cell) be activated!
Drive: ........................................................ Brushless electric motor/speed controller
Suspension: .............................................. Independent wheel suspension with spiral spring/shock-absorber,
Dimensions (L x W x H): ........................... Approx. 435 x 325 x 170mm
Tyre dimensions (W x Ø): ......................... Front approx. 52 x 101mm, rear approx. 50 x 106mm
Wheel base: .............................................. approx. 292mm
Weight: ...................................................... Approx. 1,545 g (incl. car body, without rechargeable battery pack)
Low deviations in dimensions and weight are due to production technical reasons.
15.
Declaration of Conformity (DOC)
The manufacturer hereby declares that this product complies with the essential requirements and regulations and all
other relevant provisions of the 1999/5/EC directive.
The declaration of conformity for this product can be found at www.conrad.com.
LiPo battery pack with 2 cells (rated voltage 7.4 V)
Rear-wheel drive
Ball-bearing drive
Adjustable slip clutch
Wheel alignment and camber can be set for the front axle
Camber can be set for the rear axle
adjustable
59