Reely Firestar Bedienungsanleitung Seite 51

"Battery Type"
Set the battery type you are using with this function. If the setting is incorrect then the speed controller or the recharge-
able battery may be damaged (e.g. excessive discharging of a LiPo rechargeable battery).
This delivered vehicle and the including motor are exclusively suitable for use with NiMH recharge-
able batteries with 6 cells (nominal voltage 7.2V) or LiPo rechargeable batteries with 2 cells (nomi-
nal voltage 7.4V).
When using a drive battery with more cells, there is a danger of fire from overheating of the speed
controller. Apart from this, the vehicle's drive will be overloaded and damaged by this (e.g. differ-
ential). Loss of guarantee/warranty!
The speed controller is pre-set for a NiMH/ battery with 6 cells. If you want to connect a 2-cell LiPo battery,
you have to reprogram the speed controller with the optionally available programming card (not included in
the delivery; must be ordered separately)! Only then will the undervoltage protection for LiPo-batteries
(3.0 V per cell) be activated!
"Neutral Auto/Manual"
In the "Auto" setting the current position at the remote control is taken as the neutral setting when the speed controller
is switched on.
In the "Manual" setting you can programme the speed controller's neutral and full acceleration setting for forwards and
reverse later when the speed controller is switched on for the first time.
For this purpose, see chapter 10. b).
Storing the settings in the speed controller:
• Once the settings are complete press the "Enter" button, the settings made on the programming card are transferred
to the speed controller and saved, the motor emits 5 beeps.
• Turn off the speed controller ("OFF") and disconnect it from the programming card.
• Connect the speed controller to the receiver again.
Ensure correct connection, since the speed controller will not work otherwise.
• Switch on your transmitter (check battery condition!). Put the trim controls in centre position. Put the throttle/brake
lever in neutral position and let go of it.
• Place the vehicle on an appropriate surface so that the drive can turn freely.
• Switch on the speed controller ("ON"). The motor emits a variety of sounds.
 Automatic recognition of the neutral position is active (setting "Neutral Auto")
• The motor emits a confirmation sound "DO-RE-MI" to show that the speed controller is active.
• Then the motor emits a further confirmation sound ("DA-LA-DA-LA"), the current throttle/brake lever setting is saved
as the neutral setting.
• The speed controller (and consequently the vehicle) is now ready for operation.
51