Herunterladen Inhalt Inhalt Diese Seite drucken

C) Driving The Vehicle - Reely Firestar Bedienungsanleitung

1:10 ep stadium truck brushless 2.4ghz 2wd rtr
Vorschau ausblenden Andere Handbücher für Firestar:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

c) Driving the Vehicle

• Improper operation can cause serious damage to people and property! Only drive as long as you have sight contact
to the model. This is why you shouldn't drive at night.
• Only drive when your ability to react is unrestricted. Fatigue or the influence of alcohol or medication can lead to
false responses as is the case when driving a real vehicle.
• Please note that this model car must not be driven on public roads, places or streets. Also do not operate it on private
grounds without the owner's permission.
• Don't drive towards animals or people!
• Do not drive in the rain, through wet grass, water, mud or snow. The model is not waterproof or watertight.
Moisture not only causes corrosion but also damages the electronics. In a LiPo battery, entering moisture
can set the battery on fire or even cause an explosion!
• Avoid driving at very low outdoor temperatures. In cold conditions, the plastic of the car body can loose its elasticity;
in this case small accidents can already lead to damage to the model.
• Do not drive in the case of a thunderstorm, under high-voltage power lines or in the proximity of radio masts.
• As long as the vehicle is in operation you must always leave the transmitter switched on. When parking the vehicle,
always switch off the vehicle's speed controller first and disconnect the driving battery from the speed controller
completely then.
Now you may turn off the transmitter.
• The range of the transmitter decreases when the batteries are weak. Exchange the batteries or rechargeable batter-
ies for new ones.
When the car's driving battery is weak, the car gets slower or no longer responds correctly to the transmitter.
The driving battery in the vehicle is not only used for supplying the engine though the speed controller. The
speed controller also generates the voltage/current required for operating the receiver and the steering
servo.
For this, the speed controller has an integrated BEC ("Battery Eliminator Circuit").
If the voltage in the driving battery is too low, the voltage at the receiver may also drop, which may cause
the vehicle to no longer respond to the control commands at the transmitter.
In this case, stop driving at once (switch off speed controller, disconnect the driving battery from the vehicle, switch off
transmitter). Then replace the vehicle driving battery or recharge the driving battery.
• The motor and drive as well as speed controller and driving battery of the vehicle get hot during operation. Before
each change of a rechargeable battery, wait at least 5 to 10 minutes. Let the driving battery cool down completely
before charging it.
Do not touch the motor, the speed controller or the rechargeable battery until they have cooled down.
Danger of burns!
36

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis