Attaching The Exhaust Hood - hanseatic SY-103B3-P1-C81-L22-600 Gebrauchsanleitung

Page GB-12 Assembly
(5)
225 mm 225 mm
240 mm 240 mm
(6)
4. Mark the 2 safety drill holes (6).
NOTICE
The safety drill holes (6) must be
165 mm below the wall bracket drill
holes (5). They are spaced 240 mm
apart, i.e. located 120 mm from each
side of the reference line.
The drill holes should now have the same
pattern as the diagram above.
5. Insert all 4 wall plugs into the drill holes.

Attaching the exhaust hood

(7)
(1)
1. Screw 2 fixing screws into the upper wall
plugs. Around 1 cm of both fixing screws
must be left protruding.
2. Hook the exhaust hood (1) onto the two
upper fixing screws using the hangers (7).
3. Lift up the exhaust hood cover (8).
(9)
4. Slide the grease filter lock (9) sideways
and carefully remove the grease fil-
ter (10).
(5)
2x
(8)
(10)
(11)