Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attaching the exhaust hood
(5)
(6)
1. Screw 2 fixing screws into the upper screw
plugs so that both screws are protruding
about 1 cm.
2. Carefully hang the Exhaust hood (1) on
the keyhole openings (5) on the two upper
screws.
(5)
)
)
(1)
3. If necessary, remove the Exhaust hood
again and loosen or tighten the screws in
order to ensure that it is flush with the wall.
Please note: The Exhaust hood is not yet
secured against falling down.
Assembly
(7)
4. Fold the cover (7) up.
5. Slide the lock (8) of the grease filter (9) to
the side and carefully remove the grease
filter.
2x
6. Screw two fixing screws to secure the
Exhaust hood through the securing open-
ing (6) into the prepared dowels and screw
the Exhaust hood to the wall.
Page EN-13
(8)
(9)
(6)
Werbung
Kapitel
Inhaltsverzeichnis
