Herunterladen Inhalt Inhalt Diese Seite drucken

Place The Drill Holes; Attaching The Exhaust Hood - hanseatic SY-3503C-E4-C55-L52-600 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für SY-3503C-E4-C55-L52-600:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Page EN-18
Assembly

Place the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
surfaces and the lower edge of the
hood must be at least 65 cm for gas
cookers.
For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the cooker, first use a
pencil to draw a vertical guiding line on
the wall. Ideally, use a level or a plumb
bob from the ceiling of the room to the
middle of the cooker.
2. Draw the five drill holes on the wall, fol-
lowing the upper diagram. Pay attention
to the hole distance and horizontal orien-
tation of the wall brackets.
3. Drill holes at the marked points, using a
diameter that can accommodate the dow-
els.
4. Place the dowels into the holes.

Attaching the Exhaust hood

(5)
(h)
(h)
1. Insert the two halves of the check
valve (5) into the opening on top of the
Exhaust hood (1). Make sure that the pins
(h) are on the outside of the valves.
(12)
(8)
2. Screw the wall bracket (8) for the exhaust
hood into the dowels using three round-
head screws (12).
3. Hook the exhaust hood onto the wall
bracket (8).
(5)
(5)
(5)
(5)

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis