Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before getting started
• Read chapter (see "For your safety" on
page EN-4) and all the safety notices.
Place the drill holes
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
Exhaust hood must be at least 65 cm
for gas cookers.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the cooker, first use a
pencil to draw a vertical guiding line on
the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
cooker.
2. Draw the six drill holes on the wall accord-
ing to the diagram on page EN-16. Make
sure the distances between the holes are
correct.
3. Drill holes at the marked points, using a
diameter that can accommodate the dow-
els.
4. Place the dowels into the holes.
Assembly
Attaching the Exhaust hood
(14)
)
) )
(15)
5. Place the two halves of the check
valve (14) into the opening on the top of
the Exhaust hood .
Make sure that the pins (15) on the valve
are facing outwards.
6. Screw the two round-head screws (12) for
hanging the Exhaust hood into the wall
plugs.
There must be enough space between the
wall and the heads of the screws so that
the Exhaust hood exhaust hood can be
hung by the keyhole openings.
7. Flip the cover (6) up.
8. Open the locks (7) on the grease filter (8)
and carefully remove the grease filter (8).
Page EN-17
(14)
(6)
(7)
(8)
Werbung
Inhaltsverzeichnis
