Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Assembly
Prerequisites for installation
You have read chapter „For your safety" on
page GB-4 and understand all the safety no-
tices.
Place the drill holes
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
The distance between the cooking
■
surfaces and the lower edge of the
exhaust hood must be at least 65 cm
for gas cookers.
For gas stovetops, you must read the
■
user manual for the cooktop! If the
manual stipulates a larger distance,
this must be observed.
Assembly
guideline
1. To position the appliance exactly over the
centre of the cooker, first draw a refer-
ence line on the wall (a vertical line drawn
using a level or plumb-bob from the cen-
tre of the cooker to the ceiling).
2. Hold the wall bracket against the wall so
that the distance between the exhaust
hood and cooker is at least 65 cm, and
use a pencil to mark the two drill holes
through the hangers.
NOTICE
The distance between the drill holes
and the lower edge of the exhaust hood
is 340 mm. You must therefore add 340
mm to the distance between the cook-
er and the lower edge of the exhaust
hood; in this case: 650 mm + 340 mm =
990 mm (99.0 cm).
3. Drill a hole with the same diameter as the
wall plug into the wall to a sufficient depth
at each of the marked points.
Page GB-11
Werbung
Kapitel
Inhaltsverzeichnis
