Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before getting started
• Read chapter "Safety" on page EN-4 and
all the safety notices.
Place the drill holes
WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■ Before drilling the holes, ensure that
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■ The distance between the cooking
surfaces and the lower edge of the
exhaust hood must be at least 65 cm
for gas cookers.
■ For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use a
pencil to draw a vertical guiding line on the
wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
2. Following the diagram shown above, draw
the six drill holes on the wall. Make sure
the distances between the holes are cor-
rect.
3. Drill holes at the marked points, using a di-
ameter that can accommodate the dowels.
4. Place the dowels into the holes.
Assembly
Attaching the exhaust hood
(5)
Pins
1. Place the two halves of the check valve (5)
into the opening on the top of the exhaust
hood (1).
Make sure that the pins on the valve are
facing outwards.
2. Screw the two round-head screws (11) for
hanging the exhaust hood into the dowels.
There must be enough space between the
wall and the heads of the screws so that the
exhaust hood can be hung by the keyhole
openings.
(15)
(14)
3. Flip the cover (13) up.
4. Open the locks (14) on the grease fil-
ter (15) and carefully pull it downwards to
remove.
Page EN-13
(5)
(13)
Werbung
Inhaltsverzeichnis
