Before Getting Started; Placing The Drill Holes; Attaching The Exhaust Hood - hanseatic SY-103E9A-P1-C84-L121-600 Gebrauchsanleitung

Before getting started

• Read chapter "Safety" on page EN-4 and
all the safety notices.

Placing the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
Before drilling the holes, ensure that
■
no wires or cables (power, gas, water
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
Improper handling of the appliance
can lead to fi re.
The distance between the cooking
■
surfaces and the lower edge of the
exhaust hood must be at least 65 cm
for gas cookers.
For gas stovetops, you must read the
■
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the cooker, first use a
pencil to draw a vertical guiding line on
the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
cooker.
2. Draw the six drill holes on the wall accord-
ing to the diagram on page EN-12. Make
sure the distances between the holes are
correct.
Assembly
3. Drill holes at the marked points, using a
diameter that can accommodate the dow-
els.
4. Place the dowels into the holes.

Attaching the exhaust hood

(5)
1. Place the check valve (5) into the opening
on the top of the exhaust hood (1).
Make sure that the pins on the valve are
facing outwards.
2. Screw the 2 round-head screws (11) for
mount the exhaust hood into the dowels.
There must be enough space between
the wall and the heads of the screws so
that the exhaust hood can be hung by the
keyhole openings.
3. Flip the cover (15) up.
4. Open the locks (16) on the grease fil-
ter (17) and carefully remove the grease
filter (17).
Page EN-13
(15)
(16)
(17)