Place The Drill Holes; Attaching The Exhaust Hood Attachment - hanseatic SY-103D5-E7-C59-L52-900 Gebrauchsanleitung

Place the drill holes

WARNING
Risk of injury!
Improper installation of the appliance
can lead to injury.
■ Before drilling the holes, ensure that
no wires or cables (power, gas, water,
etc.) will be damaged (check with a
line locator).
CAUTION
Fire hazard!
■ The distance between the cooking
surfaces and the lower edge of the
exhaust hood must be at least 65 cm
for gas cookers.
■ For gas stovetops, you must read the
user manual for the stovetop! If the
manual stipulates a larger distance,
this must be observed.
1. In order to place the appliance exactly
over the centre of the stovetop, first use
the pencil to draw a vertical guiding line
on the wall.
Ideally, use a level or a plumb bob from
the ceiling of the room to the middle of the
stovetop.
2. Following the diagram shown above,
draw the six drill holes on the wall. Make
sure the distances between the holes are
correct.
3. Drill holes at the marked points, using a
diameter that can accommodate the wall
plugs.
4. Place the wall plugs into the holes.
Assembly
Attaching the exhaust hood
attachment
(3)
Pins
1. Place the two halves of the check
valve (3) into the opening on the top of
the exhaust hood (1).
Make sure that the pins on the valve are
facing outwards.
2. Screw the two round-head screws (6) for
hanging the exhaust hood into the wall
plugs.
There must be enough space between the
wall and the heads of the screws so that
you can hang the exhaust hood exhaust
hood by the keyhole openings.
(6)
3. Carefully mount the exhaust hood on the
two round-head screws (6) on the keyhole
openings.
Page EN-13
(3)
(6)